Lectrosonics HHa/E01 Quick Start Manual page 5

ProgSw
The Programmable
Gain
Switch on the housing
Freq.
can be set to Talkback,
ProgSw
Power, Cough or a Mute
Rolloff function, or be bypassed
(none).
Rolloff
A sharp low frequency
rolloff filter protects
against breath pops
and can be used to
adjust the frequency
response to suit
personal preferences. The slope is
typically 36 dB/octave and varies slightly
as the turnover point is selected.
Compat
The HHa can be used with earlier Lec-
trosonics wireless and IFB systems and
systems from other manufacturers by
selecting the correct Compatibility Mode.
The receiver must be set to the same
mode .
Compat
StepSiz
TxPower
Phase
The available modes are as follows:
• Nu Hybrid: Digital Hybrid receivers
• Mode 3: (other brand contact the
factory)
IFB Mode: Lectrosonics IFB receiv-
•
ers
NOTE: If your Lectrosonics
receiver does not have
Nu Hybrid mode, set the
receiver to Euro Digital Hybrid
Wireless® (EU Dig. Hybrid).
www.lectrosonics.com
Gain
Freq.
ProgSw
Rolloff
Compat
Nu Hybr
StepSiz
Compat
StepSiz
TxPower
Phase
Lectrosonics wireless systems, but
25 kHz increments may be needed
for use with systems from other
manufacturers or when frequency
coordination requires it.
The Hex Code on the Main Screen
will be smaller in the 25 kHz mode
and a fraction will appear next to the
characters if a frequency in between
even 100 kHz steps is selected.
8
0
80
550.425
550.400
-40
-40 -20 0
TxPower
Output power can be set
Compat
to 100 mW to extend
StepSiz
operating range
can also suppress
TxPower
noise and dropouts to
Phase
some extent) or set to
50 mW to extend the operating life
of the batteries.
US: Selectable 25 or 100 mW
941: Selectable 50 or 100 mW
E01: Selectable 25 or 50 mW
E02: 10 mW
E06:
Selectable 50 or 100 mW EIRP
X: Selectable 50 or 100 mW
Phase
The phase (polarity) of the audio can be
inverted to match other microphone
capsules as needed.
TxPower
Phase
Rf On?
Default
The frequency can
be adjusted in 100
kHz or 25 kHz
steps to match the
receiver. 100 kHz is
the standard
increment for
Hex Code
in 25 kHz
mode
-20 0
(which
Phase
Pos
Neg
5