Table of Contents
Advertisement
5. Reconnect idler arm spring to eye bolt
and secure bolt to unit with nut. Tighten
until the nut is 6.1 cm (2.4") from the
threaded end of the eye bolt. See
Figure 30.
6. Reinstall deck drive belt. See Install Deck
Drive Belt on page 23.
ADJUSTMENTS
WARNING: AVOID INJURY.
Read and understand the
Safety section before
proceeding.
ADJUST SEAT
See Figure 33.
1. Pull seat adjustment lever up to unlock
seat.
2. Move seat to desired position.
3. Release seat adjustment lever to lock
seat in place.
Figure 33
ADJUST STEERING LEVERS
Adjust Steering Lever Height
See Figure 34.
1. Remove hardware securing steering
lever to upper control arm.
2. Place steering lever in desired adjusting
hole.
• Use upper and middle holes for highest
lever position.
• Use middle and lower holes for lowest
lever position.
3. Reinstall hardware in upper control arm.
4. Align levers side to side. See Adjust
Steering Lever Reach on page 26.
5. Fully tighten hardware.
3
4
1. Adjusting Hole
2. Mounting Hole
3. Steering Lever
4. Upper Control Arm
See Figure 35.
6. Loosen nut on hex bolt supporting
eccentric spacer.
7. Rotate eccentric spacer around hex bolt
until levers are at the same height.
8. Tighten nut.
3
3
1. Eccentric Spacer
2. Hex Bolt
3. Nut
EN - 25
1
Figure 34
1
2
Figure 35
2
Advertisement
Table of Contents
