Table of Contents
Advertisement
Test Steering
PTO Parking
Levers
Starting Interlock
1
Neutral
Off
2
Forward,
On
Neutral,
Reverse
3
Forward,
On
Neutral,
or
Reverse
Off
Operating Interlock (Engine On)
4 *
Forward,
On
Neutral,
Reverse
5 *
Forward,
On
Neutral,
or
Reverse
Off
* When operator lifts off seat.
CHECK PARKING BRAKE
1. Place unit in service position. See
Service Position on page 18.
2. Set both transaxle bypass levers in the
rear position. See Move Unit Manually on
page 17.
3. Push unit forward.
• If unit does not move forward, no further
action is needed.
• If unit easily moves forward, adjust the
brake lever. See Adjust Parking Brake
Lever on page 26.
CHECK ENGINE OIL
NOTICE: Engine oil level must be maintained
at correct level or engine damage may occur.
Refer to engine manual.
Result
Brake
On
Engine
starts.
On or
Engine does
Off
not start.
Off
Engine does
not start.
On or
Engine
Off
shuts off.
Off
Engine
shuts off.
CHECK TIRE PRESSURE
See Specifications on page 33 for
recommended tire pressure.
CHECK FASTENERS
Check for loose or missing hardware.
LUBRICATE UNIT
See Figure 18.
1. Place unit in service position. See
Service Position on page 18.
2. Apply grease to seat tracks through slots
under seat plate.
3. Return seat to operating position and
slide seat back and forth to spread
grease along tracks.
EN - 19
WARNING: AVOID INJURY.
Explosive separation of tire
and rim parts is possible.
• DO NOT inflate tires above
the recommended pressure.
• DO NOT inflate tires with a
compressor; use a hand
pump.
• DO NOT stand in front of
tire assembly when
inflating. Use a clip-on
chuck and extension hose
long enough to allow you to
stand to one side.
• DO NOT mount a tire
without proper equipment
and experience.
Figure 18
Advertisement
Table of Contents
