Check Mower Belts - Ariens IKON-X 42 CE Operator's Manual

Figure 24
3. Place U1 battery in battery tray so
terminals are positioned toward the front
of unit.
4. Install battery bracket over battery and
onto bolts in battery tray. Secure with two
flange nuts. See Figure 25.
1
1. Positive Battery Terminal
2. Negative Battery Terminal
Figure 25
5. Connect positive cable to positive battery
terminal and then the negative cable to
negative battery terminal.
6. Return seat to operating position.
Clean Battery
1. Remove battery from unit. See Remove
Battery on page 21.
2. Clean terminals and battery cable ends
with a wire brush.
3. Coat terminals with dielectric grease or
petroleum jelly.
2
4. Reinstall battery. See Install Battery on
page 21.
Charge Battery
Check battery with a voltmeter. If battery is
less than 11 volts, charge battery.
NOTICE: DO NOT fast charge. Charging at a
higher rate damages or destroys the battery.
ONLY use an automatic charger designed for
use with your battery.
IMPORTANT: Always follow information
provided on battery by battery manufacturer.
Contact battery manufacturer for detailed
information about charging.
IMPORTANT: Ariens does not recommend
jump starting your unit. Jump-starting can
damage engine and system components.
Refer to engine manual for detailed
information.
1. Remove battery from unit. See Remove
Battery on page 21.
2. Place battery on bench or other well-
ventilated area.
3. Connect positive lead of charger to
positive battery terminal.
4. Connect negative lead of charger to
negative battery terminal.
5. Charge battery following battery
manufacturer's instructions.
6. Reinstall battery. See Install Battery on
page 21.

CHECK MOWER BELTS

Check belts for wear and replace as needed.
Remove Deck Drive Belt
1. Stop engine, remove key and wait for all
moving parts to stop and for hot parts to
cool.
2. Lower deck to lowest cutting height.
See Figure 26.
3. Remove self-tapping screws from each
belt cover and remove belt covers. Retain
all parts for reinstallation.
4. Disconnect idler spring from spring
bracket to release belt tension.
EN - 22
CAUTION: Keep body parts
away from idler when
releasing idler spring tension.