Power Module Leds - H3C S6850 Series Manual

Table5-10 Copper management Ethernet port LED description for the LS-6850-56HF-H3
switch
LED mark
LINK/ACT

Power module LEDs

The LSVM1AC650, LSVM1DC650, SW-A-PSR550-12A-B, and SW-B-PSR550-12A-B power
modules each provide a power module LED on the panel to show the power input status and power
output status. For more information about LED status, see Table5-11.
Table5-11 LED description for the LSVM1AC650 and LSVM1DC650 power modules
LED status
Steady green
Flashing green
Steady red
Alternating between
red and green
Flashing red
Off
Table5-12 LED description for the SW-A-PSR550-12A-B and SW-B-PSR550-12A-B power
modules
LED status
Steady green
Flashing green (1 Hz)
Flashing green (0.33
Hz)
Flashing green (2 Hz)
Steady amber
Flashing amber (1 Hz)
Off
Status Description
Steady green The port is operating at 10/100/1000 Mbps.
Steady green and
The port is receiving or sending data.
flashing yellow
Off No link is present on the port
Description
The power module is operating correctly and is a primary power module.
The power module is operating correctly and is a secondary power module.
The power module is faulty or enters protection state.
An alarm occurs on the power module when one of the following conditions exists
on the power module but the power module does not enter protection state:
•
Output overvoltage.
•
Output undervoltage.
•
Output overcurrent.
•
Output power overload.
•
Overtemperature.
The current power module has no current input. If the device has two power
modules installed and one module has current input and the other does not, the
LED for the module without current input will flash red.
The power module has no current input.
Description
The power module is operating correctly.
Power is being input correctly but the system is not powered on.
The power module is in standby state and does not output power.
The power module is updating its firmware.
•
The power module is faulty.
•
The power module does not have power input, but the other power module
has correct power input.
An alarm has occurred on the power module.
No power modules have power input, which can be caused by an incorrect power
5-51