Cmp25 Ram+ Microphone Installation - Standard Horizon PHANTOM Series PS2000 Owner's Manual

2. Connect the red power wire to a 13.8 VDC ±20% power source. Connect
the black power wire to a negative ground.
3. If an optional remote extension speaker is to be used, refer to next section
for connections.
4. It is advisable to have a Certified Marine Technician check the power output
and the standing wave ratio of the antenna after installation.
8.3 MICROPHONE INSTALLATION
The Phantom PS2000 is capable of connecting 2 RAM+ microphones
(or VH-310 Handset) to control all functions.
1. Connect the RAM+ MIC Cable to the RAM MIC CONNECTOR on the rear
panel of the Phantom PS2000, then tighten the Cable Nut (See Figure 2).
2. Referring to Figure 3, make a 1.2" (30 mm) hole in the wall, then insert the
RAM+ MIC Cable into this hole. Connect the Gasket and Mount Base to the
RAM+ MIC Cable Connector using the Nut.
3. Drill the four Screw holes (approx. 2 mm) on the wall, then install the Mounting
Base to the wall using four screws.
4. Connect the CMP25 RAM+ Microphone or VH-310 Handset to the RAM+
MIC Cable Connector. The installation is now complete.
5. Wires for a external speaker are provided on the RAM+ mic cable. Connect
the STANDARD HORIZON MLS-300 or MLS-310 speaker or any 8 Ohm
external speaker. When connected the RAM+ controls the volume level of
this speaker.
Phantom PS2000
Figure 2
NOTE
Black and White wires are for
connection of a MLS-300 or
MLS-310 external speaker
Wall
RAM MIC Cable
Gasket
Mounting Bracket
Nut
Figure 3
Cap
Page 11