Cleaning The Spark Plug - Stihl MS 462 Instruction Manual

Table of Contents

Advertisement

15 Cleaning
1
2
► Rotate the shroud fasteners (1) a quarter turn
counterclockwise.
► Remove the shroud (2).
► Clean the area around the air filter (3) with a damp cloth
or a soft brush.
► Rotate the air filter (3) a quarter turn counterclockwise by
hand.
► Remove the air filter (3).
► Rinse away coarse dirt from the outside of the filter (3)
under running water.
► If the air filter (3) is damaged. Install a new air filter (3).
WARNING
Cleaning agent may cause irritation if it contacts the skin or
eyes.
► Observe the information supplied with the cleaning agent.
► Avoid contact with cleaning agents.
► In case of contact with the skin: Wash affected areas with
plenty of water and soap.
► In case of contact with the eyes: Rinse eyes with plenty of
water for at least 15 minutes and seek medical advice.
► Spray the outside and inside of the air filter (3) with STIHL
special cleaner or a cleaning agent with a pH value higher
than 12.
► Allow STIHL special cleaner or cleaning agent to act for 10
minutes.
► Use a soft brush to clean the outside of the air filter (3).
0458-786-0121-A
► Rinse the outside and inside of the air filter (3) under
3
running water.
► Allow air filter (3) to dry in the air.
► Push the air filter (3) into place by hand and rotate it
clockwise until it engages in position.
The "STIHL" logo is horizontal.
► Place the shroud (2) in position.
► Rotate the shroud fasteners (1) clockwise until you hear a
click.
The shroud fasteners (1) are locked.

15.4 Cleaning the Spark Plug

► Shut off the engine and engage the chain brake.
► Allow chainsaw to cool down
1
► Rotate the shroud fasteners (1) a quarter turn
counterclockwise.
3
1
English
3
35

Advertisement

Table of Contents
loading

Table of Contents