10 Checking the Saw
► Move the Master Control lever (1) to position
The engine stops and the Master Control lever (1) springs
back to position .
If the engine does not stop:
► Master Control lever to position
The engine stops.
► Do not use your chainsaw and contact your STIHL
servicing dealer for assistance.
The Master Control lever is defective.
10 Checking the Saw
10.1 Checking the Chain Sprocket
► Shut off the engine.
► Disengage the chain brake.
► Remove the chain sprocket cover.
► Remove the bar and chain.
a
► Use a STIHL gauge to check the wear marks on the
sprocket.
► If wear marks are deeper than a = 0.5 mm: Do not use your
chainsaw and contact your STIHL servicing dealer for
assistance.
The chain sprocket must be replaced.
0458-786-0121-A
10.2 Checking the Guide Bar
.
► Shut off the engine and engage the chain brake.
► Remove the chain and guide bar.
.
► Measure depth of bar groove with scale on STIHL filing
► Install a new guide bar if one of the following points
► If you have any queries: Contact your STIHL servicing
10.3 Checking the Saw Chain
► Shut off the engine and engage the chain brake.
gauge.
applies:
– Guide bar is damaged.
– Measured bar groove depth is less than specified
minimum depth, @ 19.3.
– Bar groove is pinched or splayed.
dealer for assistance.
2
English
1
23