Table of Contents
Advertisement
Figure 82
1. Cap
2. Filler neck (hydraulic-fluid
reservoir)
3.
Remove the dipstick from the filler neck and
wipe it with a clean rag.
4.
Insert the dipstick into the filler neck; then
remove it and check the fluid level.
Note:
The fluid level should be within 6 mm
(1/4 inch) of the mark on the dipstick.
5.
If the level is low, add the specified fluid to raise
the level to the full mark; refer to
Specifications (page
Important:
Do not overfill the hydraulic
reservoir.
6.
Install the dipstick and cap onto the filler neck.
Hydraulic Fluid Capacity
13.2 L (3.5 US gallons); refer to
Specifications (page 57)
Changing the Hydraulic
Fluid
Service Interval: Every 2,000 hours—If you
are using the recommended
hydraulic fluid, change the
hydraulic fluid.
Every 800 hours—If you are not using the
recommended hydraulic fluid or have ever
filled the reservoir with an alternative fluid,
change the hydraulic fluid.
WARNING
Hot hydraulic fluid can cause severe burns.
Allow the hydraulic fluid to cool before
performing any maintenance to the hydraulic
system.
3. Dipstick
Hydraulic Fluid
57).
Hydraulic Fluid
If the fluid becomes contaminated, contact your
authorized Toro distributor because the system must
be flushed. Contaminated fluid looks milky or black
when compared to clean oil.
1.
Prepare the machine for maintenance; refer to
Preparing for Maintenance (page
2.
Disconnect the hydraulic hose
remove the hydraulic filter
the hydraulic fluid into a drain pan.
g341294
1. Filter head
fitting
1. Hydraulic filter
3.
Install the hydraulic hose when hydraulic fluid
stops draining.
4.
Fill the reservoir
22.7 L (6 US gallons) of hydraulic fluid; refer to
Hydraulic Fluid Specifications (page
Important:
specified. Other fluids could cause system
damage.
58
42).
(Figure
(Figure
84) and drain
Figure 83
2. Hose clamp
3. Hydraulic hose
Figure 84
2. Filter head
(Figure
85) with approximately
Use only the hydraulic fluids
83) or
g353456
g353457
57).
Advertisement
Table of Contents
