Maintenance; Maintenance Safety; Recommended Maintenance Schedule(S) - Toro Reelmaster 3105-D Operator's Manual

Maintenance

Note:
Determine the left and right sides of the machine from the normal operating position.
Note:
Download a free copy of the electrical or hydraulic schematic by visiting www.Toro.com and searching
for your machine from the Manuals link on the home page.
Important:
Refer to your engine owner's manual and cutting unit Operator's Manual for additional
maintenance procedures. Maintenance Safety

Maintenance Safety

•
Before you leave the operator's position, do the
following:
– Park the machine on a level surface.
– Disengage and lower the cutting units.
– Engage the parking brake.
– Shut off the engine and remove the key.
– Wait for all movement to stop.
– Allow the machine to cool before adjusting,
servicing, cleaning, or storing it.
•
Wear appropriate clothing, including
eye-protection; long pants and substantial,
slip-resistant footwear. Keep hands, feet, clothing,
jewelry, and long hair away from moving parts.
•
Allow machine components to cool before
performing maintenance.

Recommended Maintenance Schedule(s)

Maintenance Service
Interval
After the first hour
After the first 10 hours
After the first 50 hours
Before each use or daily
Every 25 hours
Every 50 hours
Every 100 hours
Every 150 hours
Maintenance Procedure
• Torque the wheel nuts.
• Torque the wheel nuts.
• Check the condition and tension of all belts.
• Change the oil and the oil filter.
• Inspect the seat belt(s) for wear, cuts, and other damage. Replace the seat belt(s) if
any component does not operate properly.
• Check the interlock system.
• Check the engine-oil level.
• Drain the water separator.
• Check the tire pressure.
• Check the engine-coolant level.
• Clean the radiator and oil cooler.
• Check the hydraulic lines and hoses.
• Check the level of the hydraulic fluid.
• Check the reel-to-bedknife contact.
• Check the electrolyte level (if machine is in storage, check every 30 days).
• Lubricate all bearings and bushings (lubricate all bearings and bushings daily when
conditions are dusty and dirty).
• Check the condition and tension of all belts.
• Change the oil and the oil filter.
•
If possible, do not perform maintenance while the
engine is running. Keep away from moving parts.
•
Operate the engine only in well-ventilated areas.
Exhaust gases contain carbon monoxide, which
is lethal if inhaled.
•
Support the machine with jack stands whenever
you work under the machine.
•
Carefully release pressure from components with
stored energy.
•
Keep all parts of the machine in good working
condition and all hardware tightened.
•
Replace all worn or damaged decals.
•
To ensure safe, optimal performance of the
machine, use only genuine Toro replacement
parts. Replacement parts made by other
manufacturers could be dangerous, and such use
could void the product warranty.
39