Table of Contents
Advertisement
D-6
WELDER / GENERATOR
MAINTENANCE
STORAGE: Store in clean, dry protected areas.
CLEANING: Blow out the generator and controls peri-
odically with low pressure air. Do this at least once a
week in particularly dirty areas.
BRUSH REMOVAL AND REPLACEMENT: It's nor-
mal for the brushes and slip rings to wear and darken
slightly. Inspect the brushes when a generator over-
haul is necessary.
CAUTION
• Do not attempt to polish slip rings while the
engine is running.
WARNING
• Service and Repair should only be performed by
Factory Trained Personnel. Unauthorized repairs
performed on this equipment may result in dan-
ger to the technician and machine operator and
will invalidate your factory warranty. For your
safety and to avoid Electrical Shock, please
observe all safety notes and precautions.
------------------------------------------------------------------------
MAINTENANCE
DX500e (CE) (RED-D-ARC)
D-6
Advertisement
Table of Contents
