Huawei OptiXstar EG8010Hv6-10 Quick Start Manual page 5

Huawei OptiXstar EG8010Hv6-10
Quick Start for QR code
Mounting an ONT onto a Wall
1.
2.
3.
Issue 02 (2022-11-02)
Mark two positions with the same spacing as that between the two mounting
holes of the ONT using a marker on a wall.
Select a proper drill bit according to the outer diameter of the screws. Use a
hammer drill to drill the marked positions on the wall. Then clean the holes
and install two expansion bolts.
Use a screwdriver to fasten the screws into the expansion bolts, reserving 3
mm ends out of the wall, and mount the ONT onto the screws.
NO TE
It is recommended that the screw be about 4 mm in diameter and longer than 20 mm. The
screw head should be between 6mm and 9mm in diameter.
Copyright © Huawei Technologies Co., Ltd.
1 Placing the Device
2