Table of Contents
Advertisement
DRAINING THE GAS BOOSTER WATER HEATER
•
Turn off the water heater (refer to
•
Open a hot tap (preferably the shower outlet).
•
Unscrew the two drain plugs, one each at the cold water inlet and hot water outlet, on the underside of
the in-series gas booster.
Water will drain from the in-series gas booster.
•
When water stops flowing from the in-series gas booster, close the hot tap.
Note: It is recommended not to screw the drain plugs back in, until the water heater is to be turned on again.
VICTORIAN CUSTOMERS
Notice to Victorian Customers from the Victorian Building Authority. This water heater must be installed by a
licensed person as required by the Victorian Building Act 1993.
Only a licensed person will give you a Compliance Certificate, showing that the work complies with all the
relevant Standards. Only a licensed person will have insurance protecting their workmanship for 6 years. Make
sure you use a licensed person to install this water heater and ask for your Compliance Certificate.
DOES THE WATER CHEMISTRY AFFECT THE WATER HEATER?
The water heater is suitable for most public water supplies, however some water chemistries may have
detrimental effects on the water heater, components and fittings. Refer to
If you are in a known harsh water area or you are not sure of your water chemistry, have your water checked
against the conditions
described on pages
HOW LONG WILL THE WATER HEATER LAST?
The water heater is supported by a manufacturer's warranty
that will affect the length of service the water heater will provide. These include but are not limited to the water
chemistry, the water pressure, the water temperature (inlet and outlet) and the water usage pattern. Refer to
"Precautions"
on page 12.
"Turn Off The Water Heater"
18
to
20.
(refer to page
15
ABOUT YOUR WATER HEATER
on page 14).
"Water Supplies"
on page 18.
4). There are a number of factors
Advertisement
Table of Contents
