Rheem 596160 Owner's Manual And Installation Instructions page 10

Gas boosted water heater
Table of Contents

Advertisement

SAFETY, WARNINGS, INSTALLATION NOTES
INSTALLATION NOTES
This water heater must be installed:
by a qualified person,
in accordance with the installation instructions,
in compliance with the Plumbing Code of Australia (PCA) and Plumbing Standard AS/NZS 3500.4,
This water heater is designed for outdoor installation.
This water heater is intended to be permanently connected to the water mains and not connected by
a hose-set. A braided flexible hose or semi-flexible connector may be used for connection to the water
heater, where permitted by AS/NZS 3500.4.
in compliance with the Gas Installations Standard AS/NZS 5601.1,
in compliance with the Australian / New Zealand Wiring Rules AS/NZS 3000,
in compliance with all local codes and regulatory authority requirements.
Installation and commissioning requirements and details for the installing plumber and licensed electrical
worker are contained on
Mains pressure water supply
The water heater is designed to operate at mains pressure by connecting directly to the mains water supply.
The water heater is supplied with a temperature pressure relief valve with a pressure rating of 1000 kPa. If an
expansion control valve has been installed on the cold water line to the water heater, this should have a
pressure rating of 850 kPa.
The maximum mains water supply pressure for the water heater is 800 kPa if an expansion control valve is
not installed, or 680 kPa if an expansion control valve is installed. If the mains supply pressure in your area
exceeds these values, a pressure limiting valve must be installed.
The supply pressure should be greater than 120 kPa for the rated flow and performance of the gas booster to
be achieved.
The supply pressure should be greater than 350 kPa for true mains pressure operation to be achieved.
Securing of the water heater
The top of the solar storage tank is to be secured to the wall with the wall bracket and suitable fasteners for
the wall type and load bearing requirements. Refer to
pages
27
to
66.
"Wall Brackets"
on page 29 for additional information.
10

Advertisement

Table of Contents
loading

This manual is also suitable for:

Premier solar ll 160lPremier solar loline

Table of Contents