Hilti NURON NCR 60 DC-22 Manual page 10

▶ If the battery is too hot to touch, it may be defective. Put the battery in a place where it is clearly visible
and where there is no risk of fire, at an adequate distance from flammable materials. Allow the battery to
cool down. If it is still too hot to touch after an hour, the battery is faulty. Consult Hilti Service or read the
document entitled "Instructions on safety and use for Hilti Li-ion batteries".
Observe the special guidelines applicable to the transport, storage and use of lithium-ion batteries.
→ page 12
Read the instructions on safety and use of Hilti Li-ion batteries that you can access by scanning
the QR code at the end of these operating instructions.
3 Description
3.1 Product overview
3.2 Intended use
The product described is a cordless, electro-hydraulic crimping tool.
It is designed for crimping connection material made of copper (Cu) or aluminum (Al).
Before work commences, all live cables and other equipment carrying electric voltage within the area in
which the user is working must be switched off. If this is not possible, the corresponding safety precautions
for working in proximity to live cables or equipment must be implemented and observed.
• For this product, use only Hilti Nuron lithium-ion batteries of the B 22 series. For optimum performance,
Hilti recommends the batteries stated in the table at the end of these operating instructions for this
product.
• For these batteries, use only Hilti chargers of the type series stated in the table at the end of these
operating instructions.
3.3 Possible misuse
• Do not use this hand-held crimping tool clamped in a fixed position or as a stationary device.
• Do not use the electro-hydraulic crimping tool in heavy rain or under water.
3.4 Coated crimping head
NCR 60 DC-22
DANGER
Electricity presents a risk of fatal accident! Contact with electrically live lines can lead to severe physical
injury and/or death.
▶ The crimping tool is not insulated! If you use this crimping tool in the vicinity of electrically live lines, wear
personal protective equipment.
The crimping head of the NCR 60DC-22 has a PVC coating. The PVC coating is red, the housing underneath
is colored black.
6 English
1
Crimping head
@
Piston return switch
;
Servicing and fault indicator
=
Battery release button
%
Battery status indicator
&
Battery
(
Installation opening for accessories
)
Work-area light
+
Control switch
§
Crimping/pressing ram
/
Pivoting bar
:
Tab
∙
2321726
*2321726*