Table of Contents
Advertisement
BATTERY CHARGER'S SIMPLIFIED STATUS
On pin 4 of the RJ45 CAN OUT socket, a signal which indicates the operating status of the battery charger (presence or
absence of problems) is located (Fig. 4).
PIN 4 CAN OUT
STATE
CONNECTION
Battery charger switched off or presence
HIGH IMPEDANCE
of problems requiring manual reset.
Battery charger switched on and absence
+ V OUTPUT
of any problem requiring manual reset.
BATTERY TEMPERATURE SENSOR
A temperature sensor for the batteries (KTBRJ) can be connected to the RJ11 socket.
WARNING: in case a KTB4N interface (optional, with one or more sensors) is connected, the KTBRJ sensor
connected to the RJ11 socket will be automatically disabled.
BATTERY TYPE SELECTION
Select the type of battery to be charged by turning the selector on the front panel of the battery charger.
WARNING: select the battery type only when the battery charger is switched off.
Refer to the table below to select the type of batteries you want
NUMBER
BATTERY TYPE
*
0
EL open
1
EL sealed
2
GEL
3
AGM
4
Optima
®
5
Li-lon
6
RESERVED
7
RESERVED
8
RESERVED
9
RESERVED
KTBRJ
TEMPERATURE SENSOR
BATTERY
12V - 24V
*
Factory settings
FIG. 4
BATTERY
SENSOR CONNECTOR
to charge:
INSTALLATION
5
4
CAN OUT
2
3
EN
Advertisement
Table of Contents
