Battery Temperature Sensor; Battery Type Selection - Quick SBC 1100 NRG+ FR Manual Of Installation And Use

BATTERY CHARGER'S SIMPLIFIED STATUS
On pin 4 of the RJ45 CAN OUT socket, a signal which indicates the operating status of the battery charger (presence or
absence of problems) is located (Fig. 4).
PIN 4 CAN OUT
STATE
CONNECTION
Battery charger switched off or presence
HIGH IMPEDANCE
of problems requiring manual reset.
≃
Battery charger switched on and absence
+ 13,5 Vdc
of any problem requiring manual reset.

BATTERY TEMPERATURE SENSOR

A temperature sensor for the batteries (KTBRJ) can be connected to the RJ11 socket.
WARNING: in case a KTB4N interface (optional, with one or more sensors) is connected, the KTBRJ sensor
connected to the RJ11 socket will be automatically disabled.

BATTERY TYPE SELECTION

Select the type of battery to be charged by turning the selector on the front panel of the battery charger.
WARNING: select the battery type only when the battery charger is switched off.
Refer to the table below to select the type of batteries you want to charge:
NUMBER BATTERY TYPE
0*
EL open
1 EL sealed
2 GEL
3 AGM
4 Optima
®
5 Li-lon
6
RESERVED
7 RESERVED
8 RESERVED
9 RESERVED
+
SBC NRG HIGH REV001B
KTBRJ
TEMPERATURE SENSOR
BATTERY
12V - 24V
* Factory setting
INSTALLATION
FIG. 4
BATTERY
SENSOR CONNECTOR
EN
5
4
CAN OUT
2
3
21