Responding To The Notification Of Upgrade; Voice Announcement; Site Selectable Alerts (Astro 25 Trunking) - Motorola APX 8000 User Manual

Hide thumbs Also See for APX 8000:
Table of Contents

Advertisement

MN001422A01-AW
Chapter 7 : Advanced Features
7.20.1

Responding to the Notification of Upgrade

When and where to use: If a configuration upgrade is downloaded to your radio, an alert tone sounds
and the upgrade is installed at the next radio power up. If a firmware upgrade is downloaded to your
radio, an alert tone sounds and the display shows UPGRADE.
Procedure:
1 To accept the upgrade, long press the Top Side (Select) button within 15 seconds of UPGRADE
appearing on the display.
NOTE: Do not remove the power cable or power down the radio during the firmware
upgrade process.
The radio resets and the installation take several minutes.
NOTE: The radio cannot be used while the upgrade is being installed. Therefore, make
sure to only accept the upgrade at a convenient time when immediate radio use is not
required.
If the Top Side (Select) button is not long pressed within 15 seconds, the UPGRADE display is
cleared until the next radio power up.
7.21

Voice Announcement

This feature enables the radio to audibly indicate the current feature mode, zone, or channel assigned
to the user.
The available voice announcement (VA) priority options are:
High
Voice announcement is enabled even when the radio is receiving calls.
Low
Voice announcement is disabled when the radio is receiving calls.
NOTE: If the Voice Announcement field is set to Enabled, after an interruption by a
momentary tone one of the following scenarios occurs:
If Suppress Replay field is Enabled, voice announcement replays.
If Suppress Replay field is Disabled, voice announcement turns off.
7.22

Site Selectable Alerts (ASTRO 25 Trunking)

A Site Selectable Alert (SSA) is an Intelligent Lighting indicator with audio alert. The alert is sent to
radios at sites to notify the users when special situations occur.
Your radio supports up to 250 site aliases. Only authorized radios are enabled to send SSA.
NOTE:
The alert alias, alert tone, and alert period are configured in the Customer Programming
Software (CPS). For more information, contact your system administrator.
The SSA alert volume is reduced when voice audio is received at the same time. It is important
that the SSA audio file is created with clear loud audio to ensure audio clarity at reduced levels.
68

Advertisement

Table of Contents
loading

Table of Contents