Connecting Water Supply; Connecting To The Drain - Beko WMI 71441 User Manual

Installation
3. Attach the plastic covers supplied in the
User Manual bag into the holes on the rear
panel. (P)
C
Keep the transportation safety
bolts in a safe place to reuse when
the washing machine needs to be
moved again in the future.
Never move the product without
the transportation safety bolts
properly fixed in place!

3.4 Connecting water supply

C
The water supply pressure required
to run the product is between 1 to 10
bars (0.1 – 1 MPa). It is necessary to
have 10 – 80 liters of water flowing
from the fully open tap in one minute
to have your machine run smoothly.
Attach a pressure reducing valve if
water pressure is higher.
If you are going to use the double
water-inlet product as a single
water-inlet unit, you must install the
supplied stopper to the hot water
valve before operating the product.
(Applies for the products supplied
with a blind stopper group.)
A
WARNING:
water inlet should not be connected
to the hot water tap. In such a case
the laundry will get damaged or the
product will switch to protection
mode and will not operate.
WARNING:
water inlet hoses on the new product.
It may cause stains on your laundry.
1. Connect the special hoses supplied with the
product to the water inlets on the product.
Blue hose (right) (max. 25 ºC) is for cold
water inlet.
12 / EN
(cold)
Models with a single
Do not use old or used
A
WARNING:
hot water connections are made
correctly when installing the product.
Otherwise, your laundry will come out
hot at the end of the washing process
and wear out.
2. Tighten all hose nuts by hand. Never use a
tool when tightening the nuts.
3. Open the taps completely after making
the hose connection to check for water
leaks at the connection points. If any leaks
occur, turn off the tap and remove the nut.
Retighten the nut carefully after checking
the seal. To prevent water leakages and
damages caused by them, keep the taps
closed when the machine is not in use.

3.5 Connecting to the drain

• The end of the drain hose must be directly
connected to the wastewater drain or to the
washbasin.
• Drain hose shall be attached to a wall drain,
stand pipe or sink siphon connected to the
foul water drain, do not connect to surface
water drains.
Ensure that the cold and
Washing Machine /User's Manual