Electrolux F13GN User Manual page 20

20 www.electrolux.com
2. Release the screw (C), which keeps
the burner in position.
C
3. Carefully move the burner off the
injector support (D).
E
4. Slowly move it to the left side. Do not
apply force to the wire of the spark
plug connector (F) and to the
thermocouple conductor (E).
5. Release the burner injector (D) with a
7 mm socket spanner and replace it
with a different one which is
necessary for the type of gas you
use.
Refer to "Technical information"
chapter.
6. Assemble the burner in a reverse
sequence.
Replace the gas type sticker near the
gas supply ramp with the one related to
the new gas type.
The gas oven burner does not need any
primary gas regulation.
D
F
Make sure that the gas
supply pressure of the
appliance obeys the
recommended values.
If the supply gas pressure is
changeable or different from
the necessary pressure, you
must fit an applicable
pressure adjuster on the gas
supply pipe.
12.4 Minimum level adjustment
of the oven burner
1. Disconnect the appliance from the
electricity.
2. Turn the knob for the gas control to
the minimum position and remove it.
3. Adjust the adjustment screw (A) with
a thin-bladed screwdriver.
Change of
the type of
gas
From natural
gas to liquid
gas
From liquid
gas to natu‐
ral gas
4. Attach the knob for the gas control.
5. Connect the appliance to the
electricity.
A
Adjustment
of the ad‐
justment
screw
Fully tighten
the adjust‐
ment screw
in.
Release the
adjustment
screw ap‐
proximately
1/3 of a turn.