Adjusting The Cutting Height - Toro 22232 Operator's Manual

Adjusting the Cutting Height

DANGER
Adjusting the height-of-cut could bring your hands into contact with a moving blade and
result in serious injury.
• Shut off the motor, remove the battery, and wait for all moving parts to stop before adjusting
the cutting height.
• Do not put your fingers under the housing when adjusting the cutting height.
The cutting height is controlled with a front lever and a rear lever, both on the left side of the machine. To raise
or lower the machine, engage the lever, raise or lower the machine, and then disengage the lever.
1. 38 mm (1–½ inches)
2. 51 mm (2 inches)
3. 64 mm (2–½ inches)
4. 76 mm (3 inches)
Figure 12
5. 89 mm (3–½ inches)
6. 102 mm (4 inches)
7. 114 mm (4–½ inches)
8. 127 mm (5 inches)
14
g426490