Preparing The Battery Pack For Recycling - Toro 22232 Operator's Manual

Figure 40
1. Parking-brake cable
2. Adjustment nut
3. Handle (right side)
3. Adjust the tension on the cable
pulling or pushing the cable jacket and holding
that position.
Note:
Pull the cable jacket toward the motor to
increase tension (also increases brake clamp
load); push the cable jacket away from the motor
to decrease tension (also decreases brake
clamp load).
Important:
Adjust the cable jacket in small
increments to avoid over tensioning. Over
tensioning may cause the machine to not
roll free even when the parking brake is
disengaged. Correct tensioning allows the
machine to roll free when the parking brake
is disengaged and to hold position when the
parking brake is engaged.
4. Turn the adjustment nut clockwise to tighten the
cable adjustment.
Note:
Tighten the nut firmly with a socket or
wrench.
g427828
4. Turn the nut clockwise to
tighten the adjustment.
5. Turn the nut
counterclockwise to
loosen the adjustment.
(Figure 40) by
Preparing the Battery Pack
for Recycling
Important:
Upon removal, cover the terminals of
the battery pack with heavy-duty adhesive tape.
Do not attempt to destroy or disassemble the
battery pack or remove any of its components.
Lithium-ion battery packs labeled with the
Call2Recycle seal can be recycled at any
participating retailer or battery recycling
facility in the Call2Recycle program (US
and Canada only). To locate a participating
retailer or facility closest to you, please call
1-800-822-8837 or visit www.call2recycle.org.
If you cannot locate a participating retailer or
facility nearby, or if your rechargeable battery
is not labeled with the Call2Recycle seal,
please contact your local municipality for more
information on how to responsibly recycle the
battery. If you are located outside of the US
and Canada, please contact your authorized
Toro distributor.
30