Cleaning Under The Machine - Toro 22232 Operator's Manual

3. Slide the battery pack into the charger until it is
fully seated (Figure
4. To remove the battery pack, slide the battery
backward out of the charger.
5. Refer to the following table to interpret the LED
indicator light on the battery charger.
Indicator Indicates
light
Off No battery pack inserted
Green Battery pack is charging
blinking
Green Battery pack is charged
Red Battery pack and/or battery charger is over or under
the appropriate temperature range
Red Battery pack charging fault*
blinking
*Refer to Specifications (page 11)
information.
Important:
The battery can be left on the charger
for short periods between uses.
If the battery will not be used for longer periods,
remove the battery from the charger; refer to
Storage (page 31).

Cleaning under the Machine

For optimal cutting performance, keep the underside
of the machine housing clean. You may either wash
or scrape the clippings away from under the machine
housing.
WARNING
The machine may dislodge material from
under the machine.
• Wear eye protection.
• Stay in the operating position (behind the
handle) when the motor is running.
• Do not allow bystanders in the area.
Washing under the Machine
Service Interval: After each use—Clean under the
machine housing.
1. Position the machine on a flat concrete or
asphalt surface near a garden hose.
2. Start the machine.
3. Hold the running garden hose at handle level
and direct the water to flow on the ground just in
front of the right rear wheel
23).
for more
(Figure 24).
1. Right rear wheel
Note:
The blades will draw in water and wash
out clippings. Let the water run until you no
longer see clippings being washed out from
under the machine.
4. Shut off the machine and wait for all moving
parts to stop.
5. Turn off the water.
6. Start the machine and let it run for a few minutes
to dry out the moisture on the machine and its
components.
Scraping Method
If washing does not remove all debris from under the
machine, scrape it clean.
1. Shut off the machine and wait for all moving
parts to stop.
2. Remove the electric-start button and the battery
from the machine.
3. Tip the machine onto its side.
4. Remove the dirt and grass clippings with a
scraper. Avoid contacting any burrs or sharp
edges.
5. Return the machine to the operating position.
21
Figure 24
g002275