Benelli TRK 702 Owner's Manual page 57

Periodic maintenance and adjustment
Tightening torque:
Engine oil drain bolt:
24 N·m
EN 9. Refill with the specified amount of the
recommended engine oil, and then install
and tighten the oil filler cap.
6
Reccomended Engine oil:
API SN - SAE
SAE viscosity grades:
10W50
API classification:
SN
Oil quantity:
2,4 +/- 0,1 L
(with oil filter replacing)
2,2 +/- 0,1 L
(without oil filter replacing)
NOTE
Be sure to wipe off spilled oil on any parts
after the engine and exhaust system have
cooled down.
NOTICE
• In order to prevent clutch slip-
page (since the engine oil also
lubricates the clutch), do not mix
any chemical additives. Do not
use oils with a diesel specification
of "CD" or oils of a higher quality
than specified. In addition, do not
use oils labeled "ENERGY CONSER-
VING II" or higher.
• Make sure that no foreign mate-
rial enters the crankcase.
10. Start the engine, and then let it idle for
several minutes while checking it for oil
leakage. If oil is leaking, immediately turn
the engine off and check for the cause.
NOTE
After the engine is started, the engine oil
level warning light should go off if the oil
level is sufficient.
6 - 12
NOTICE
If the oil level warning light flashes or
stays on even if the oil level is appro-
priate, immediately run the engine and
have the vehicle checked by a Benelli
dealer.
11. Turn the engine off, wait a few minutes
until the oil settles, and then check the oil
level and correct it if necessary.