Cisco 3100 Manual page 28

SSDs
Caution
If you have only one SSD, you cannot remove it while the firewall is powered on.
Caution You cannot swap SSDs between different platforms. For example, you cannot use a 2100 series SSD in a
3100 series model. If you are swapping SSDs between two Secure Firewall 3100s, use the remove-secure
local disk command, otherwise sometimes the SED (self-encrypting drive) gets locked. If you get an error
message that the SED is locked, you can enter the PSID and the system clears the SED and creates a new set
of keys. To avoid this situation, especially if you do not know what the PSIDs are, always use the
remove-secure local disk when removing SSDs. See
for the procedures for safely removing an SSD.
See Product ID Numbers, on page 33
Figure 14: SSD
1 SSD release tab
For More Information
• See
• See
• See the configuration guide for your software for the procedures for removing and adding an SSD from
the RAID1 configuration.
Overview
28
Front Panel LEDs, on page 11
Remove and Replace the SSD
Hot Swap an SSD on the Secure Firewall 3100/4200
for a list of the PIDs associated with the Secure Firewall 3100 SSDs.
—
for the location and description of the SSD LEDs on the front panel.
for the procedure for removing and replacing the SSD.
Overview