Pro-Form PFEL55916.1 User Manual page 27

HOW TO ADJUST THE DRIVE BELT
If the pedals slip while you are pedaling, even while
the resistance is adjusted to the highest level, the drive
belt may need to be adjusted.
To adjust the drive belt, first unplug the power
adapter.
Next, use a
standard screw-
driver to remove
the Shield Cover
(75) and the Shield
Cover Cap (118).
See assembly step 15 on page 14. Remove the
Right Leg Outer and Inner Covers (69, 83).
See assembly step 12 on page 12. Remove the
Right Pedal Arm (58) from the Right Upper Body
Leg (60).
Next, remove the M8 x 16mm Screw (95) and the Axle
Cover (53) from the right Crank Arm (20). Then, care-
fully remove the Right Roller Arm (59) and the Right
Pedal Arm (58) from the elliptical.
118
75
95 53
20
58
59
See EXPLODED DRAWING C on page 35. Identify
the Left and Right Shields (73, 74). Remove the
M4 x 19mm Tek Screws (5), the M4 x 19mm Screws
(124), and the M4 x 48mm Screw (107) from the Left
and Right Shields; make sure to note the location of
each size of Screw. Then, remove the Right Shield.
Next, locate and loosen the Idler Screw (89). Tighten
the Belt Adjustment Screw (91) until the Drive Belt
(113) is tight. Then, retighten the Idler Screw.
113
Reattach the parts that you removed. Then, plug in the
power adapter.
27
89
91