Beko B3D59644UW User Manual page 49

• The detergent in the main wash compart-
ment got wet while taking in the prewash
water. Holes of the detergent compart-
ment are blocked. >>> Check the holes
and clean if they are clogged.
• There is a problem with the detergent
drawer valves. >>> Call the Authorised
Service Agent.
• Detergent was mixed with the softener.
>>> Do not mix the softener with deter-
gent. Wash and clean the drawer with hot
water.
Detergent residue on the clothes.
• The machine might have been overloaded.
>>> Do not overload the machine.
• Wrong programme and temperature were
selected. >>> Select the proper pro-
gramme and temperature for the laundry
to be washed.
• Wrong type of detergent might have been
used. >>> Select the proper detergent for
the laundry to be washed.
Too much foam forms inside the
product. (**)
• Improper detergents for the washing ma-
chine is used. >>> Use detergents appro-
priate for the washing machine.
• Excessive amount of detergent is used.
>>> Use only sufficient amount of deter-
gent.
• Detergent was stored under improper
conditions. >>> Store detergent in a
closed and dry location. Do not store in
excessively hot places.
• Some meshed laundry such as tulle may
foam too much because of their texture.
>>> Use smaller amounts of detergent for
this type of item.
• Detergent was put in the wrong compart-
ment. >>> Make sure you place the de-
tergent in the appropriate compartment.
• Softener is being taken early by the
product. >>> There may be problem in the
valves or in the detergent drawer. Call the
Authorised Service Agent.
Foam is overflowing from the detergent
drawer.
• Too much detergent is used. >>> Mix 1
tablespoonful softener and ½ l water and
pour into the main wash compartment of
the detergent drawer. >>> Put detergent
into the product suitable for the pro-
grammes and maximum loads indicated in
the "Programme and consumption table".
When you use additional chemicals (stain
removers, bleaches and etc.), reduce the
amount of detergent.
Laundry remains wet at the end of the
programme. (*)
• Excessive foam has occurred and auto-
matic foam absorption system has been
activated due to too much detergent us-
age. >>> Use recommended amount of
detergent.
Drying lasts too long.
• The machine might have been overloaded.
>>> Do not overload the machine.
• Spinning might not be sufficient for laun-
dry. >>> Select a higher spin speed in the
washing step of the Washer-Dryer.
• Tap is turned off. >>> Turn on the taps.
Laundry comes off wet after the drying
step.
• The programme selected might not be
suitable for the type of laundry. >>> Check
the care labels on clothes and select a
programme accordingly, or select timed
programmes additionally.
• The machine might have been overloaded.
>>> Do not overload the machine.
• Spinning might not be sufficient for laun-
dry. >>> Select a higher spin speed in the
washing step of the Washer-Dryer.
Machine does not start or programme
cannot be started.
• Power cable might be unplugged. >>>
Make sure that the power cable is plugged
in.
• Programme might not be set, or the Start/
Pause/Cancel button might be not
pressed. >>> Make sure the programme
is set and the machine is not in Standby
mode.
EN / 49