Troubleshooting - Beko B3D59644UW User Manual

NOTICE:
Foreign substances left in the pump
filter may damage your product or
may cause noise problem.
In regions where freezing is possible,
the tap must be closed, system
hose must be removed and the wa-
ter inside the product must be
drained when the product is not in
use.
After each use, turn off the tap to
which the mains hose is connected.
In order to clean the dirty filter and drain
the water:
a. Unplug the product to cut off the supply
power.
Temperature of the water inside the
product may rise up to 90 ºC. To
avoid the risk of scalding, clean the
filter after the water inside the
product is cooled down.
b. Open the filter cover.

8 Troubleshooting

Please read the "Safety Instructions"
section first!
Programmes do not start after the
loading door is closed.
• Start / Pause / Cancel button is not
pressed. >>> Press Start / Pause / Cancel
button.
• It may be difficult to close the loading door
in case of excessive loading. >>> Reduce
the amount of laundry and make sure that
the loading door is closed properly.
c. Follow the below procedures in order to
drain water.
If the product does not have an
emergency water draining hose, in order
to drain the water:
• Place a large container at the end of the
hose to collect the water from the filter.
• When the pump filter starts leaking water
loosen it by turning (opposite clockwise).
Fill the running water to the container you
placed in front of the filter. Keep a cloth
ready to clean the water that may spill.
• Completely turn and remove the pump fil-
ter when the water in the product leaks
out.
a. Clean any residues inside the filter as well
as fibres, if any, around the pump im-
peller region.
b. Replace the filter.
c. If the filter cap is composed of two
pieces, close the filter cap by pressing on
the tab. If it is one piece, seat the tabs in
the lower part into their places first, and
then press the upper part to close.
Programme cannot be started or
selected.
• The product has switched to self-protec-
tion mode due to a supply problem (line
voltage, water pressure, etc.). >>> De-
pending on the product model, select an-
other program by turning the Program Se-
lection button or pressing and holding the
On/Off button for 3 seconds to cancel the
program. Previous programme will be can-
celled. See Cancelling the Programme
[} 39]
EN / 45