Correcting The Distortion - Dukane 9100WUSS User Manual

Hide thumbs Also See for 9100WUSS:

Table of Contents

Installation of the Projector

Note for adjusting the lens shift

1. Adjust the lens shift / zoom / focus 30 minutes after turning on the projector.

2. Slight changes in the image position and/or focus may occur within 30 minutes after turning on the

projector. If the room temperature and humidity have changed after adjusting the lens shift / zoom / focus,

readjust as necessary.

3. In anticipation of the changes after installation, set up the image size including the margin from the screen edge.

be misaligned slightly downward over time.

8. Correcting the distortion

Press

on the remote control or Keypad. You can use

OSD to correct the distortion of a projected screen.

PERFECT FIT

KEYSTONE

Adjusts the vertical and horizontal keystone.

Note: When the horizontal lens shift is not set to the center, this function may not work correctly.

PERFECT FIT

Adjusts each of the screen corner and side to correct the distortion. For details, see User's Manual -

Operating Guide.

WARPING

Projects an image on several types of screen.

Note: Press EXIT to exit, or wait several seconds until the OSD menu automatically disappears.

Note: When the zoom adjustment is set to the TELE (telephoto focus), this function may be excessive. This function

should be used when the zoom adjustment is set to the full WIDE (wide-angle focus).

GEOMETRY CORRECTION menu.

English-

KEYSTONE

PERFECT FIT

Table of Contents