Fasten The Door Bracket - Craftsman 139.53920D Owner's Manual

NSTALLATmON STEP t t
Fasten the Door Bracket
Follow instructions which apply to your door type
as illustrated below or on the following page..
A horizontal reinforcement brace should be long
enough to be secured to two vertical supports. A
vertical reinforcement brace should cover the
height of the top panel.
The illustration shows one piece of angle iron as the
horizontaf brace.. For the vertical brace, two pieces of
angle iron are used to create a U-shaped support
(Figure 1). The best solution is to check with your
garage door manufacturer for an opener installation
door reinforcement kit.
NOTE: Many vertical brace installations provide for
direct attachment of the clevis pin and door arm tn
this case you will not need the door bracket; proceed
to Installation Step 12.
SECTIONAL BOORS
- Center the door bracket on the previously marked
vertical centerfine used for the header bracket
installation. Note correct UP placement, as
stamped inside the bracket (Figure 2)
° Position the bracket on the face of the door within
the following limits:
A) The top edge of the bracket 2"-4" (5-10 cm)
below the top edge of the door
B) The top edge of the bracket directly below any
structural support across the top of the door.
i CAUTBON
Fiberglass,aluminum or lightweightsteel garagedoors
WILL REQUIRE reinforcementBEFORE installation of
door brackeLContactyour door manufacturerfor
reinforcementkit
HARDWARE SHOWN ACTUAL SIZE
Nut 5115"q8 LockWasher 51_6'
Carriage Bo]!
5!16"-t 8x2-1/2"
. Mark and drill 5/16" left end right fastening holes..
Secure the bracket as shown in Figure 1 if there is
vertical reinforcement.
If your installation doesn't require verticai
reinforcement but does need top and bottom
fastening holes for the door bracket, fasten as shown
in Figure 2
Header Bracket
Horizontal and vertical reinforcement
is needed for lightweight garage doors
doors w_th
Figure 1
Figure 2
23