Compliance Statements; Fcc; Ised Canada - Elatec MULTITECH 2 M HF User Manual

6 COMPLIANCE STATEMENTS

6.1 EU
Hereby, ELATEC GmbH declares that TWN4 MultiTech 2 M HF is in compliance with Directive 2014/53/EU. The full text of the EU
declaration of conformity is available at the following internet address: elatec.com/approvals
RF exposure statement
TWN4 MultiTech 2 M HF complies with EU radiation exposure limits set forth for an uncontrolled environment under the following
conditions: The equipment should be installed and operated such that a minimum separation distance of 20 cm is maintained between
the antenna and user's/nearby person's body at all times.
6.2

FCC

FCC ID: WP5TWN4F12
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause undesired operation. (except receivers
associated with operation of a licensed radio service and stand-alone devices).
Caution
The Federal Communications Commission (FCC) warns the users that changes or modifications to the unit not expressly approved by
the party responsible for compliance could void the user's authority to operate the equipment.
FCC §15.105 (b)
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC
Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
•
Reorient or relocate the receiving antenna.
•
Increase the separation between the equipment and receiver.
•
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
•
Consult the dealer or an experienced radio/TV technician for help.
RF exposure statement
TWN4 MultiTech 2 M HF complies with FCC radiation exposure limits set forth for an uncontrolled environment under the following
conditions: This equipment should be installed and operated such that a minimum separation distance of 20 cm is maintained between
the antenna and user's/nearby person's body at all times.
6.3

ISED CANADA

IC: 7948A-TWN4F12
This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic Development
Canada's licence-exempt RSS(s). Operation is subject to the following two conditions:
1. This device may not cause interference.
2. This device must accept any interference, including interference that may cause undesired operation of the device.
© 2023 ELATEC GmbH – TWN4 MultiTech 2 M HF user manual – DocRev03 – EN – 07/2023 Page 10 of 14