Troubleshooting - Hyundai FSB 050 WW8E Instruction Manual

Cleaning
For hygienic reasons the appliance interior, including interior accessories, should be cleaned
regularly.
CAUTION! The appliance may not be connected to the mains during cleaning. Danger of
electrical shock! Before cleaning switch the appliance off and remove the plug from the
mains, or switch off or turn out the circuit breaker or fuse. Never clean the appliance with
a steam cleaner. Moisture could accumulate in electrical components, danger of electrical
shock! Hot vapors can lead to the damage of plastic parts. The appliance must be dry
before it is placed back into service.
IMPORTANT! Ethereal oils and organic solvents can attack plastic parts, e.g. lemon juice
or the juice form orange peel, butyric acid, cleanser that contain acetic acid.
• Do not allow such substances to come into contact the appliance parts.
• Do not use any abrasive cleaners
• Remove the food from the freezer. Store them in a cool place, well covered.
• Switch the appliance off and remove the plug from the mains, or switch off or turn out the
circuit breaker of fuse.
• Clean the appliance and the interior accessories with a cloth and lukewarm water. After
cleaning wipe with fresh water and rub dry.
• After everything is dry place appliance back into service.
Defrosting of the freezer
The freezer compartment, however, will become progressively covered with frost. This should
be removed. Never use sharp metal tools to scrape off frost from the evaporator as you could
damage it.However, when the ice becomes very thick on the inner liner, complete defrosting
should be carried out as fellows:
• Pull out the plug from the socket;
• Remove all stored food, wrap it in several layers of newspaper and put it in a cool place;
• Keep the door open, and placing a basin underneath of the appliance to collect the defrost water;
• When defrosting is completed, dry the interior thoroughly
• Replace the plug in the power socket to run the appliance again.

TROUBLESHOOTING

CAUTION! Before troubleshooting, disconnect the power supply. Only a qualified
electrician of competent person must do the troubleshooting that is not in this manual.
IMPORTANT! There are some sounds during normal use (compressor, refrigerant
circulation). These sounds are not a reason for complaint!
Problem
Appliance does not work
Possible cause
Temperature regulation knob is
set at number "0".
Mains plug is not plugged in or is
loose.
Fuse has blown or is defective
(circuit breaker is OFF).
Socket is defective
ENG - 45
Solution
Set the knob at other number
to switch on the appliance.
Insert mains plug.
Check fuse, replace if
necessary (switch ON the
circuit breaker).
Mains malfunctions are to be
corrected by an electrician.
ENG