26
Power Save Option
This function is important for power conservation. If the power saving function is not set during battery pack use, the
number of splice cycles will decrease.
(1) Insert a power unit and turn on the splicer.
(2) Select [Power Save Option] in [System Setting] menu.
(3) Change value of [Monitor Shut Down] and [Splicer Shut Down]
Parameter
Monitor Shut Down
Splicer Shut Down
8.5 System Information
After selecting [System Information], the following messages will be shown on the screen:
Parameter
Machine Serial NO.
Software Version
FPGA Version
Total Arc Count
Current Arc Count
Last Maintenance
Production Date
To avoid power loss when battery is used, setting this function turns off the power supply to
the LCD monitor if the splicer does not operate after a certain period of time. When the power
supply for monitor turns off, the LED near the power key [
the LCD monitor.
Automatically turns off the power supply of the splicer if it performs no operation for a long
period of time. The function serves to prevent the battery capacity from running low.
Display the fusion splicer' s serial number.
Display the fusion splicer' s software version.
Display FPGA' s version.
Display total arc discharge count.
Display arc discharge count after electrode change. The parameters will be zero cleared or
reset after replacing electrodes.
Display maintenance date at last time.
Display the date of production of the machine.
Description
]blinks. Press any key to turn on
Description
VIEW 5 Pro
Need help?
Do you have a question about the VIEW 3 Pro and is the answer not in the manual?