Table of Contents
Advertisement
B. OPERATING INSTRUCTIONS
CONTROL PANEL
Run
Indicator light illuminates to signify the cooling mode is currently in
operation
Light
To turn on/ off the inner light
Power
To switch on/ off the appliance (press and hold for approximately 3
seconds)
Up
Press once to raise the temperature by 1⁰C
Down
Press once to lower the temperature by 1⁰C
Display
To indicate the temperature of the internal cabinet
TEMPERATURE SETTING
Connect the power cord to a properly grounded outlet. In the event of a power
interruption, all previous temperature settings will be automatically erased and it will
default to a preset temperature setting of 12℃.
Set the desired cooling temperature by pressing the "UP/DOWN" buttons. The
temperature selected will flash in the LED display for approximately 5 seconds, then
revert back to display the temperature of the internal cabinet
The temperature setting can be adjusted from 5℃ to 18℃ .
Attention:
If the appliance is unplugged or power lost occurred, you must wait 3 to 5 minutes
before restarting the appliance. If you attempt to restart before this time delay, the
wine cooler will not start. For first time use or long period of non-use, the
temperature will differ between the setting temperature and the LED display
temperature. The temperature will revert back to normal after running for a period.
REMOVING SHELVES
Attention:
To prevent damaging the door gasket, make sure to have the door all the way
opened when pulling shelves out of the rail compartment.
For easy access to the storage content, you must pull the shelves approximately 1/3
out of the rail compartment, however this unit was designed with a notch on each
sides of the shelf tracks to prevent bottles from falling.
To fit or remove the shelf, tilt the shelf as below diagram and simply pull out or push into
Advertisement
Table of Contents
