Reversing The Door - Scandomestic SKS 56 B User Manual

Reversing the Door

This product has the door hinges on the right. If you wish to change
the opening direction, follow the instructions below:
1． Remove the upper hinge cover (6) first.
2． Remove the two screws (1) that hold the upper hinge (5)
(right side) to the frame. Remove the upper hinge (5).
3． Lift the door and place it on a padded surface to prevent
scratching.
4． Remove the two screws (8) that hold the lower hinge (2).
Remove the lower hinge (2).
5． Remove the left front leg (4) and transfer it to the right side.
6． Remove the hole cover plate (7) to the right side.
7． Install the lower hinge (2) onto the left side of the lower
frame with the two screws through the opposite two holes
(8).
8． Set the door in its place making sure it sits on the door seat
at the lower hinge (2).
9． While holding the door in a closed position, secure the
upper hinge (5) on the top left side with the two screws (1)
through the opposite two holes. Do not tighten the two
screw (1) until the top of the door is leveled with the
countertop.
10． Install the upper hinge cover (6) on the upper hinge.
1． Screw
2． Lower hinge
3． Leveling legs
4． Leveling legs
5． Upper hinge
6． Upper hinge cover
7． Hole cover plate
8． Opposite two holes