Electrical Connection; Reversing The Door - Scandomestic SFS 61 W User Manual

poor air circulation can affect performance.
Built-in appliances should be positioned
away from heat sources such as heaters
and direct sunlight.
Leveling
• The appliance should be level in order
to eliminate vibration. To make the ap-
pliance level, it should be upright and
both adjusters should be in stable con-
tact with the floor. You can also adjust
the level by unscrewing the appropriate
level adjustment in the front (use your
fingers or a suitable spanner).

Electrical connection

CAUTION
Any electrical work required to install this
appliance should be carried out by qualified
or authorized personnel.
WARNING
This appliance must be grounded. The
manufacturer declines any liability should
these safety measures not be observed.
Ventilation of appliance
In order to improve efficiency of the cooling
system and save energy, it is necessary to
maintain good ventilation around the ap-
pliance for the dissipation of heat. For this
reason, sufficient clear space should be
available around the refrigerator.
Suggest: It is advisable for there to be 50-70
mm of space from the back to the wall, at
least 100 mm from its top, at least 100 mm
from its side to the wall and a clear space
upfront to allow the doors to open 135°. As
shown in follow diagrams.

Reversing the door

The side at which the door opens can be
changed from the right side (as supplied) to
the left side, if the installation site requires.
Tools you will need:
• 8 mm socket driver
• Cross-shaped screwdriver
• Putty knife or thin-blade screwdriver
Before you start lay the refrigerator on it's
back in order to gain access to the base,
you should rest it on soft foam packaging or
similar material to avoid damaging the cool-
ing pipes at the rear of the refrigerator.