Reversing The Door - Scandomestic WKS263W User Manual

in the appliance.
•
NOTE: High temperature setting will in-
crease food waste.
Changing the LED light
If the LED light is damaged. DO NOT CHANG
IT BY YOURSELF!
Changing the LED light by inexperienced per-
sons may cause injury or serious malfunction-
ing. It must be replaced by a qualified person
to avoid a hazard. Contact your local Service
Force Center for help.
•
Before changing the LED light, switch off
the appliance and unplug it, or pull the
fuse or the circuit breaker.
•
LED light data: 220-240V, MAX 2W
•
Unplug the mains plug.
•
To change the LED light, undo the screw.
•
Changing the defective LED light.
•
Put the refrigerator back into operation.
•
Light source: LED. Light energy class: G.

Reversing the door

The side the door opens can be changed,
from the right side (as supplied) to the left
side, if required.
Warning! When reversing the door, the appli-
ance must not be connected to the mains. En-
sure that the plug is removed from the mains
socket.
Tools you will need (not provided):
8mm socket wrench
-
Thing blade screwdriver
-
Putty knife
-
Cross shaped screwdriver
-
Monkey wrench
-
8mm wrench
-
Left hinge cover (included in plastic bag)
-
Note: If required you may lay the refrigerator
on its back to gain access to the base, you
should rest it on soft foam packaging or simi-
lar material to avoid damaging the backboard
of the refrigerator.
To reverse the door, the following steps
should be followed.
1. Place the refrigerator upright.
Open the upper door to take out all
door racks (to avoid damage) and
then close the door.
2. Use a putty knife or thin-blade
screwdriver to prize the screw hole
cover which is at the top left corner
of the refrigerator,
hinge cover which is at the top right
corner of the refrigerator.
3. Use a 8mm socket driver or a span-
ner. Unscrew the special flange
self-tapping screws which are used
for fixing the right upper hinge part
(please support the upper door
with your hand when doing it).
and the upper