Numatic HFS 1023 Owner's Instructions Manual page 8

ORIGINAL INSTRUCTIONS
READ MANUAL BEFORE USE
Operators shall be adequately instructed on the use of this machine.
This machine shall be disconnected from its power source (Remove plug from socket outlet.)
During cleaning or maintenance or in the event of an accident and when replacing parts or
converting the machine to another function.
WARNING
This machine is not suitable for picking up hazardous dust.
Do not allow supply cord to come into contact with the rotating brushes or pads
As with all electrical equipment care and attention must be exercised at all times during its use, in addition to ensuring that routine and preventive
maintenance is carried out
Periodically in order to ensure its safe operation. Failure to carry out maintenance as necessary, including the replacement of parts to the correct
standard could render the equipment unsafe and the manufacturer can accept no responsibility or liability in this respect.
When ordering spare parts always quote the model number / serial number specified on the rating plate.
This machine is for indoor use only.
The machine is not to be used or stored outdoors or in wet conditions.
Don't allow the machine to be used by inexperienced or unauthorised operators or without appropriate training.
Only use brushed provided with the appliance or those specified in the instruction manual.
The use of other brushes may impair safety.
A full range of brushes and accessories are available for this product.
Only use brushes or pads which are suitable for the correct operation of the machine for the specific task being preformed.
It is essential that this equipment is correctly assembled and operated in accordance with current safety regulations. When using the equipment
always ensure that all necessary precautions are taken to guarantee the safety of the operator and any other persons who may be affected.
This machine is not suitable for picking-up hazardous dust.
Do not use on surfaces having a gradient exceeding that marked on the appliance.
This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience
and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety.
Children should be supervised to ensure that they do not play with the appliance.
The machine is not to be stored outdoors in wet conditions.
This machine is for indoor use only.
Read the instruction manual before using the appliance.
This product meets the requirements of BS EN / IEC 60335-2-67.
CAUTION
NOTE: The primary use for this machine is commercial, for example in hotels, schools, hospitals, factories, shops and office.
• Ensure only competent persons unpack/assemble the machine.
• Keep your machine clean.
• Keep your brushes in good condition.
• Replace any worn or damaged parts immediately.
DO
• Regularly examine the power cord for damage, such as cracking or ageing. If damage is found, replace the cord before further use.
• Only replace the power cord with the correct Numatic approved replacement parts.
• Ensure that the work area is clear of obstructions and / or people.
• Ensure that the working area is well illuminated.
• Pre-sweep the area to be cleaned.
• Use steam cleaners or pressure washers to clean the machine or use in the rain.
• Attempt machine maintenance or cleaning unless the power plug has been removed from the supply outlet,
if the machine is in charge mode or remove the key if in normal use.
• Allow any inexperienced repairs. Contact your nearest service centre.
DON'T
• Strain charger lead or try to unplug by pulling on charger lead.
• Leave your machine standing on brush, pads or drive boards when not in use.
• Expect the machine to provide trouble-free, reliable operation unless maintained correctly.
• Run the machine over any power cables during operation.
Machine Maintenance
Daily
Keep the machine clean.
Ensure brushes / pads are in good condition.
Check for any worn or damaged parts and replace immediately.
Do not leave your machine standing on the brush, pads or drive boards when not in use.
8
www.numatic.co.uk
Information for Scrubber Dryer
Weekly - as daily and:
Regularly examine the power cord.