During Operation; During Operation Safety - Toro 74312 Operator's Manual

Understanding the
Safety-Interlock System
The safety-interlock system is designed to prevent the
engine from starting unless:
•
The parking brake is engaged.
•
The PTO-engagement lever is disengaged.
•
The speed-control lever is in the N
The safety-interlock system is designed to stop the
engine when you rise from the seat when the PTO
is engaged.
The hour meter has symbols to notify you when the
interlock component is in the correct position. When
the component is in the correct position, a triangle
lights up in the corresponding square.
Figure 14
1. Triangles light up when
the interlock components
are in the correct position.
2. Hopper up
Testing the Safety-Interlock
System
Service Interval: Before each use or daily
Test the safety-interlock system before you use the
machine each time. If the safety system does not
operate as described below, have an Authorized
Service Dealer repair the safety system immediately.
1. Sit on the seat, engage the parking brake,
move the PTO-engagement lever to the O
position, and move the speed-control lever to
the N position. Try starting the engine;
EUTRAL
the engine should not start.
2. Sit on the seat, engage the parking brake, and
move the PTO-engagement lever to the O
position. Move the speed-control lever out of the
N position. Try starting the engine; the
EUTRAL
engine should not start.
position
EUTRAL
g020563
3. Hour/Voltage display
4. Low-voltage indicator light
N
FF
3. Sit on the seat, disengage the parking brake,
move the PTO-engagement lever to the O
position, and move the speed-control lever to
the N position. Try starting the engine;
EUTRAL
the engine should not start.
4. Sit on the seat, engage the parking brake,
move the PTO-engagement lever to the O
position, and move the speed-control lever to the
N position. Now start the engine. While
EUTRAL
the engine is running, release the parking brake,
engage the PTO-engagement lever, and rise
slightly from the seat; the engine should shut off.
5. Sit on the seat, engage the parking brake,
move the PTO-engagement lever to the O
position, and move the speed-control lever to
the N position. Now start the engine.
EUTRAL
Move the speed-control lever forward; the
engine should shut off.

During Operation

During Operation Safety

General Safety
•
The owner/operator can prevent and is responsible
for accidents that may cause personal injury or
property damage.
•
Wear appropriate clothing, including eye
protection; slip-resistant, substantial footwear; and
hearing protection. Tie back long hair and do not
wear jewelry.
•
Do not operate the machine while ill, tired, or
under the influence of alcohol or drugs.
•
Never carry passengers on the machine and keep
bystanders and pets away from the machine
during operation.
•
Operate the machine only in good visibility to avoid
holes or hidden hazards.
•
Avoid mowing on wet grass. Reduced traction
could cause the machine to slide.
•
Ensure that all drives are in neutral, the parking
brake is engaged, and you are in the operating
position before you start the engine.
•
Keep your hands and feet away from the cutting
units. Keep clear of the discharge opening at all
times.
•
Look behind and down before backing up to be
sure of a clear path.
•
Use care when approaching blind corners, shrubs,
trees, or other objects that may obscure your
vision.
20
FF
FF
FF