The Safety-Interlock System - Toro 74312 Operator's Manual

Figure 11
1. Hairpin cotter and clevis pin
5. Loosen the locknuts on the rear studs of the
FRS baffles.
Figure 12
1. PTO guard removed for
clarity
6. Raise the mower deck; refer to
Mower Deck into the Service Position (page
7. Remove the bolt and washer at the front of each
FRS baffle (Figure
8. Rotate the baffles into the desired position and
install the bolt and washer.
2. Loosen the locknuts.
Raising the
13).
g006787
1. Baffles—closed position
2. Baffles—open position
3. Bolt
4. Washer
5. Baffles
9. Lower the mower deck; refer to
Mower Deck to the Operating Position (page
g025242
10. Slightly tighten the locknuts on the rear studs
of the FRS baffles.
Note:
The locknuts on the rear studs may be
left slightly loose if you anticipate adjusting the
baffle frequently.
11. Install the PTO guard using the clevis pins and
17).
hairpin cotters removed in step 3.
The Safety-Interlock
System
CAUTION
If the safety-interlock switches are
disconnected or damaged, the machine could
operate unexpectedly, causing personal
injury.
• Do not tamper with the interlock switches.
• Check the operation of the interlock
switches daily and replace any damaged
switches before operating the machine.
19
Figure 13
Lowering the
g007577
18).