Attach The Guard; Assemble The Shaft; Attach The Auxiliary Handle - GreenWorks STF456 Operator's Manual

WARNING
• If the parts are damaged, do not use the machine.
• If you do not have all the parts, do not operate the
machine.
• If the parts are damaged or missing, speak to the service
center.
1. Open the package.
2. Read the documentation in the box.
3. Remove all the unassembled parts from the box.
4. Remove the machine from the box.
5. Discard the box and package in compliance with local
regulations.
8.2

ATTACH THE GUARD

WARNING
Do not touch the cut-off blade.
1. Put the shaft into the groove of the guard.
2. Put the bracket (1) into the slot (2).
2
3. Align the screw hole on the bracket with the screw hole
on the guard.
4. Tighten with the wing screw.
English
8.3

ASSEMBLE THE SHAFT

1. Loosen the knob (1) on the coupler.
2. Push in the release button (2) on the lower shaft (3).
3. Align the release button (2) with the positioning hole (4)
and slide the two shafts.
3
4. Turn the lower shaft until the button locks into the
positioning hole.
2
5. Tighten the knob.
1
8.4 ATTACH THE AUXILIARY
HANDLE
1. Remove the screws from the handle with a Phillips
screwdriver (not provided).
2. Attach the auxiliary handle and lower clamp on the shaft.
3. Set the auxiliary handle in the comfortable position.
4. Tighten the screws.
7
4
2
1
5
LOOSEN
TIGHTEN
1
EN
5