Table of Contents
Advertisement
ATTENTION!
If there is water on the cooking compartment floor
when operating the appliance at temperatures above
120 °C, this will damage the enamel.
▶
Do not use the appliance if there is water on the
cooking compartment floor.
▶
Wipe away any water on the cooking compartment
floor before operation.
Requirement: The cooking compartment has cooled
down.
1.
Remove any food remnants from the cooking com-
partment.
2.
Dry the cooking compartment with a sponge.
3.
Remove limescale marks with a cloth soaked in vin-
egar, then wipe with clean water and dry with a soft
cloth.
4.
Leave the cooking compartment to dry with the ap-
pliance door open for 1 hour or use "Drying func-
tion".
→ "Setting 'Drying function'", Page 21
19 Rails
Ra i l s
To thoroughly clean the rails and the cooking compart-
ment, or to replace the rails, you can remove the rails.
19.1 Detaching the rails
WARNING ‒ Risk of burns!
The shelf supports get very hot
▶
Never touch the shelf supports when hot.
▶
Always allow the appliance to cool down.
▶
Keep children at a safe distance.
1.
Lift the rail forwards slightly
2.
Pull the whole rail to the front
3.
Clean the rail.
→ "Cleaning products", Page 18
20 Appliance door
Appl i a n c e do o r
To clean the appliance door thoroughly, you can disas-
semble the appliance door.
and detach it
.
and remove it.
18.2 Setting "Drying function"
Requirement: → "Drying the cooking compartment",
Page 20
1.
Press "Cleaning".
2.
Press "Drying function".
a The duration appears on the display. You cannot
change the duration of the drying function.
3.
Start the drying function using
a A notification stating that you should carry out the
necessary preparatory work for the drying function
appears on the display.
4.
Press "OK" to confirm the notification.
a The drying function starts. The duration counts down
on the display.
a Once the drying function has run through to the
end, an audible signal sounds.
5.
Leave the appliance door open for 1-2 minutes so
that the cooking compartment dries completely.
19.2 Attaching the rails
Notes
¡ The rails only fit on the right or left.
¡ For both rails, ensure that the curved rods are at the
front.
1.
First, push the rail into the middle of the rear
socket
until the rail rests against the cooking
compartment wall, and then push this back
2.
Push the rail into the front socket
also rests against the cooking compartment wall,
and then press this downwards
20.1 Detaching the appliance door
WARNING ‒ Risk of injury!
Components inside the appliance door may have sharp
edges.
▶
Wear protective gloves.
Rails en
.
.
until the rail
.
21
Advertisement
Table of Contents
