SPECIAL SAfETy INSTRUCTIONS fOR THIS UNIT
• Make sure the power supply meets the voltage marked on the label before power on the
appliance.
• Do not cover unit at any time.
• Do not place or use near bath, shower or swimming pools.
• Ensure that no object, flammable or otherwise is closer than one metre to heat source.
• The unit must be used in any hazardous area or be in contact with any kind of fuel, oil, gas or
substance such as explosives etc.
• Always route the power cable from the back of the unit.
• Do not use the unit of of doors.
• Always place and use the unit on a horizontal position, otherwise the tip-over switch will be
activated.
• Do not use this heater with a programmer, timer or any other device that switches the heater
is covered or positioned incorrectly.
• Do not place the unit just below the socket.
DESCRIPTION Of THE CONTROLS
P1 Switch
P2 Back cover
P3 Reflect base
P4 Front net
P5 Heating element
P6 Front cover
P7 Base
INSTRUCTIONS fOR USE
OPERATION STEPS:
1) Check the heating element before using it.
2) Put the heater on the flat place
3) Insert the plug in to a suitable socket
4) Power steps:
Position 0: The heater is „Off"
Position 1: The heater in condition1 ---400 watts.
Position 2: The heater in condition2 ---800 watts.
5) After using it, turn the switch on position "0", and pull out the plug.
ENG - 15
ENG