Image Location; Channel Out - Yamaha YRS-2500 Owner's Manual

IMAGE LOCATION

➜
SETUP MENU
If sound from the left and right channels is unnatural, first adjust the volume of each
channel (p. 36, 49).
If this does not resolve the problem, adjust left- and right-channel image location.
Use to adjust the direction from which the front left and right channel sound is heard so
that each sound can be heard closer to the center channel.
You can adjust this parameter only when "5BEAM+2", "5BEAM" or "3BEAM" is selected
in "Switching between audio output methods for surround playback" (p. 34).
❑ ADJUSTMENT
Settings
OFF (default) No adjustments are made.
ON Choose "LEFT" or "RIGHT" to adjust the direction from which sound is heard.
❑ LEFT
The higher the percentage, the louder the output from the center channel.
Once "ADJUSTMENT" has been set to "ON", this setting can be selected.
Control range
0% (default) to 95%
Left-channel sound is
unnatural
48
Setup menu
En
➜
BEAM IMAGE LOCATION
With the front left channel
adjusted
❑ RIGHT
The higher the percentage, the louder the output from the center channel.
Once "ADJUSTMENT" has been set to "ON", this setting can be selected.
Control range
0% (default) to 95%
Right-channel sound is
unnatural

CHANNEL OUT

➜
SETUP MENU BEAM
Specify the sound beam output method (5.1ch, 7.1ch, AUTO).
Settings
5.1ch 5.1-channel output
7.1ch 7.1-channel output
Sound beams are output from the appropriate number of channels based on
input signal as follows.
AUTO (default)
– 2- or 5.1-channel input: 5.1-channel output
– 6.1- or 7.1-channel input: 7.1-channel output
• The available sound beam output methods vary depending upon the current "CHANNEL OUT" setting
(p. 34).
With the front right channel
adjusted
➜
CHANNEL OUT