Advanced Setup List - Yamaha YRS-2500 Owner's Manual

Advanced setup list

Menu
TURN ON VOLUME
MAX VOLUME
INPUT LOCK
PANEL LOCK
IR INPUT POWER
AC ON STANDBY
MEMORY PROTECT
YRB FL
YRB FR
YRB SL
YRB SR
AUTO POWER STANDBY
FW UPDATE
INITIALIZE
• Initializing this unit also initializes measurement results for IntelliBeam and settings stored in system memory. Perform "AUTO SETUP" from the "IntelliBeam" menu again.
58
Advanced setup
En
Settings/Adjustable range
OFF (Not set) (default), 1 to 70
1 to 99, MAX (Maximum) (default)
ON (INPUT key operation is disabled)
OFF (INPUT key operation is enabled) (default)
ON (Key operation on the unit is disabled)
OFF (Key operation on the unit is enabled) (default)
ON (Enables power-on)
OFF (Disables power-on) (default)
ON (Enters standby mode) (default)
OFF (Restores the state before power was lost)
ON (Protect is performed)
OFF (Protect is not performed) (default)
YES (The reflection board is used)
NO (The reflection board is not used) (default)
YES (The reflection board is used)
NO (The reflection board is not used) (default)
YES (The reflection board is used)
NO (The reflection board is not used) (default)
YES (The reflection board is used)
NO (The reflection board is not used) (default)
ON (This unit turns off automatically) (default)
OFF (This unit does not turn off automatically)
02.00.04 (The firmware version is displayed)
START OK? (Firmware is updated)
OK (All settings are restored to their default values)
CANCEL (Settings are not restored to their default values) (default)
Description
Set the initial volume level when the power of this unit is turned on.
When set to "OFF", volume level is the same as when this unit is turned off.
Set the maximum volume level so that this unit will not output sound beyond the
limited volume level.
Select whether or not to enable the INPUT key on the unit.
Select whether or not to enable key operations on the unit (except the advanced
setup operations).
Select whether or not to automatically turn on this unit by pressing an input selector
key on the remote control when the unit is turned off.
Set this unit's power to off when the AC power is recovered after the power to this
unit was lost temporally (disconnect the AC power plug from the wall outlet, power
outage, etc.).
Protect the settings you have saved in the system memory.
Use the YRB-100 sound reflection board for the front left channel. Refer to page 63
for details of YRB-100.
Use the YRB-100 sound reflection board for the front right channel. Refer to page 63
for details of YRB-100.
Use the YRB-100 sound reflection board for the surround left channel. Refer to page
63 for details of YRB-100.
Use the YRB-100 sound reflection board for the surround right channel. Refer to
page 63 for details of YRB-100.
When set to "ON", this unit turns off automatically in any of the following situations:
• No operations have been performed for 8 hours or more.
• Bluetooth is selected as the playback device. However, no audio has come out
from the device or no operation has been performed for 20 minutes or more.
• HDMI 1, 2, or 3 is selected as the playback device. However, the playback
device has been disconnected from the selected HDMI IN jack for 20 minutes or
more.
Confirm firmware version/update firmware.
Reset all of the parameters of this unit to the factory presets. When the unit freezed,
the problem may solve by restoring to their default values.