Setting The Hdmi Control Function; Changing The Connection Method And Connected Devices - Yamaha YRS-2500 Owner's Manual

z
HDMI1
30
Initial settings
En

Setting the HDMI control function

1
Turn on the unit, TV, and playback devices.
2
Activate the HDMI control function on the unit, TV,
and playback devices such as BD/DVD players that
support this function.
For this unit, set "HDMI CONTROL" to "ON". The default
setting is "OFF" (p. 51).
For playback devices, refer to the manual supplied with
each device.
3
Turn off the main power of the TV and then turn off
the unit and playback devices.
4
Turn on the unit and playback devices and then turn
on the TV.
5
Switch the TV input to display the video from the
unit.
6
Select the input source of this unit to BD/DVD player
and check whether the image in the player is
correctly displayed or not.
If the BD/DVD player is connected via HDMI IN1 jack, press
the HDMI1 key.
HDMI1
7
Check that the unit is properly synchronized with
the TV by turning off the TV or adjusting the TV
volume with the TV remote control.
If the HDMI control function is not working
Be sure that all devices are correctly connected to this unit, and
that settings are properly configured as described below.
– "HDMI CONTROL" (p. 51) is set to "ON" in the setup menu.
– The HDMI control function is enabled on the TV.
The example of TV settings
• From the setup menu on your TV, select "Link setting"
control setting", then set a setting such as "HDMI control
function" to "ON".
• Set audio output to any option other than TV.
When the HDMI control function is not still working even after the
above has been checked,
– Turn off this unit and the TV, and then turn them back on again.
– Disconnect the AC power supply cable of the unit and external
devices connected to the unit via HDMI cable. Plug them in
again after about 30 seconds.
– After OPTICAL, AUX1, or AUX2 input has been enabled,
switch the input source for the TV and this unit to the devices
connected via HDMI cable.
Changing the connection method and
connected devices
When the connected devices and jacks are changed, reset this unit
with the following procedure.
1
Disable the HDMI control function of the TV and BD/
Input source name
DVD player, turn off all connected devices, and
change the connections.
2
Perform steps 1 to 7 of "Setting the HDMI control
function".
"HDMI