Sony ICF-J1 Service Manual page 8

• "GEAR (TUNING CAPACITOR)", "SPRING (GEAR)" AND "GEAR (B), TUNING CAPACITOR"
gear, midway
"GEAR (TUNING CAPACITOR)", "SPRING (GEAR)" AND "GEAR (B), TUNING CAPACITOR" SETTING
gear (tuning capacitor)
1 Turn variable condenser (CV1)
shaft fully to the arrow direction
(ant1-clok wise).
2 gear (tuning capacitor)
( Including "spring (gear)",
"gear (B), tuning capacitor".
Note: Adjust so that the triangle
marked is at the position
shown and install.
triangle mark
4 holder (gear)
5 screw (BTP3 × 12)
1 Insert the spring (gear)
into a hole in the gear
(tuning capacitor).
A
Note: Make sure that two tuning capacitor gears
are meshing with the midway gear.
gear, midway
)
3 screw (B2.6 × 5)
Note: Secure screw.
hook
2 Fit the tuning capacitor gear (B)
to the gear (tuning capacitor),
and then turn the tuning capacitor gear (B)
in the A direction.
– 8 –
triangle mark
3 Engage the spring (gear)
to the hook of the tuning
capacitor gear (B) as shown.
spring (gear)