Axis 01809-031 User Manual page 22

AXIS P13 Network Camera Series
Specifications
Function
DC ground
DC output
Input 1
Input 2
Output 1
Output 2
1 DC ground
2
DC output 12 V, max 50 mA
3
Supervised input port 1
4
Supervised input port 2
5
Digital output port 1
6
Digital output port 2
Power connector
2-pin terminal block for DC power input. Use a Safety Extra Low Voltage (SELV) compliant limited power source (LPS) with either
a rated output power limited to ≤100 W or a rated output current limited to ≤5 A.
Pin Notes
1
2
Can be used to power auxiliary equipment.
Note: This pin can only be used as power out.
3
Digital input or Supervised input – Connect to pin 1 to activate, or
leave floating (unconnected) to deactivate. To use supervised input,
install end-of-line resistors. See connection diagram for information
about how to connect the resistors.
4
Digital input or Supervised input – Connect to pin 1 to activate, or
leave floating (unconnected) to deactivate. To use supervised input,
install end-of-line resistors. See connection diagram for information
about how to connect the resistors.
5
Digital output – Internally connected to pin 1 (DC ground) when
active, and floating (unconnected) when inactive. If used with an
inductive load, e.g., a relay, connect a diode in parallel with the load,
to protect against voltage transients.
6
Digital output – Internally connected to pin 1 (DC ground) when
active, and floating (unconnected) when inactive. If used with an
inductive load, e.g., a relay, connect a diode in parallel with the load,
to protect against voltage transients.
21
Specifications
0 V DC
12 V DC
Max load = 50 mA
0 to max 30 V DC
0 to max 30 V DC
0 to max 30 V DC, open drain,
100 mA
0 to max 30 V DC, open drain,
100 mA