Assembly - Craftsman 137.218073 Operator's Manual

ASSEMBLING STAND (FIG. A, B, C)
1. Unpack all parts and group by type
and size. Refer to the parts list for
correct quantities.
2. Attach four hooks (10) to the top
corner of the four legs (2) as shown.
The hooks (10) are used to hold the
dust bag.
NOTE: Make sure the hook (10) is
securely fastened to the corner of
the leg (2).
Fig. A
10
3. Attach one long upper support (1) to
top of leg (2) using one bolt (3) and
nut (4). Only hand-tighten support
attachment bolts until stand is fully
assembled.
NOTE:
● Align detents (8) in stand leg
with support brackets to ensure
proper fit.
● Do not fully tighten bolts until
stand is properly aligned.
● Position all supports to the
INSIDE of the leg assembles.
4. Attach short upper supports (6) to
other hole of leg (2) using one bolt
and nut.

ASSEMBLY

2
5. Assemble the other upper supports
6. Attach one bottom support (5) to the
10
7. Assemble rear frame section in
2
8. Join front-bottom and rear-bottom
20 20
Fig. B
6
in exactly the same manner.
center of the leg using bolt (3) and
nut (4). This completes the front
frame section.
exactly the same manner.
frame assemblies using the bottom
support (7), bolts and nuts.
Fig. C
7
5
Front
4
3
10
8
1
6
2
1