Table of Contents
Advertisement
2. Loosen the blade bevel lock knob
and turn the handwheel to 90° on the
bevel scale.
3. Tighten the blade bevel lock knob.
4. Remove the anti-kickback pawls
assembly by lifting the locking
lever (2). (Fig. X)
5. Remove the blade guard assembly
by pressing down the red spring
button (5) and lifting up the
assembly. (Fig. AA)
AVOIDING KICKBACKS (FIG. BB)
To avoid kickback (having the work
thrown violently back toward you), keep
the blade sharp, keep the rip fence
parallel to the saw blade and keep
the riving knife, blade guard and anti-
kickback pawls in place, aligned and
functioning. Do not release the work
before passing it completely beyond
the saw blade. Do not rip work that
is twisted, warped or does not have
a straight edge to guide it along the
fence. Do not attempt to back out of a
cut with the blade running.
WARNING
!
Improper riving knife alignment can
cause "kickback" and serious injury.
Fig. BB
Anti-kickback Pawls
INSTALLING THE BATTERIES FOR
THE LASER GUIDE (FIG. CC)
WARNING
!
Failure to unplug your saw could
result in accidental starting causing
possible serious personal injury.
1. Remove the locking screw (1) on the
cover (2) of the battery compartment
with a Phillips screwdriver, and open
the battery compartment.
2. Install two "AAA" batteries.
3. Close the cover (2), and replace the
locking screw and tighten it securely.
4. Turn the switch (3) to the ON
position in order to activate the laser
cutting guide.
NOTE: See instructions on ADJUSTING
THE LASER LINE on 39.
Fig. CC
30
30
2
1
3
Advertisement
Table of Contents
